How much weight can a bolt hold up?

How much weight will a half inch bolt hold? A 1/2 inch lag bolt can hold 21,285 pounds. How much weight can 4 bolts hold? Screws give you even greater holding power, and several #4 or larger screws can hold as much as 100 pounds if driven into a wall stud. For example, you might …

Read more

Can I use screws instead of joist hangers?

Outdoors use 16d double-dipped galvanized nails (or stainless steel when called for) for installing hangers. … The manufacturers agree: Never use galvanized deck screws or drywall screws to install joist hangers. Those screws don’t have the shank size and toughness to support joist loads. Can I use structural screws instead of joist hangers? You can …

Read more

Frequent question: What size is a number 3 screwdriver?

What is #3 screwdriver? The #3 Phillips head works on screws with the numbers 10, 12, 14, and 16, and the #4 Phillips head corresponds with screws numbered 18, 20, and 24. The numbering system, while a bit hard to keep track of, is one way to determine which screwdriver works with which screw. What …

Read more

Quick Answer: Who created the Phillips screwdriver?

The Phillips screw and driver, originally invented by Portlander John P. Thompson, dramatically increased the speed of manufacturing and made the Phillips screwdriver a necessity in every toolbox. Where did the name Phillips screwdriver come from? Henry Frank Phillips (June 4, 1889 – April 13, 1958) was an American businessman from Portland, Oregon. The Phillips-head …

Read more

What bolts to use for outdoor?

Stainless steel nuts, bolts and washers are typically suitable for exterior projects and work with pressure-treated lumber. Hardened steel bolts have increased strength and are often used in automotive assemblies. What kind of bolts should I use outside? Lag screws, or lag bolts, are heavy-duty fasteners best used when attaching framing components such as posts, …

Read more

How do you attach wood to metal studs?

Wood can also be fastened to the studs by pre-drilling holes into the metal studs and then installing them with wood screws. The power on the drill may need to be adjusted and turned up to get the screw into the stud. Depending on the type of drill, the speed may vary. Metal studs are …

Read more

Can you bolt into sandstone?

Powers five-piece bolts seem to work pretty well in sandstone, but they should be at least 3″ long…the wider the better. To reduce spinners, tap the bolt in the hole partway, then snug up the bolt finger tight, then tap some more, re-snug, etc. How do you anchor into sandstone? Thread a whole bunch of …

Read more

What causes a hobnail liver?

Degeneration of the liver characterized by fatty changes, fibrous scarring, nodular degeneration, and atrophy of the liver with the surface covered with brown or yellow nodules. This condition is seen in chronic alcoholism and malnutrition. What is the hob of the liver? views 1,428,169 updated. hobnail liver (hob-nayl) n. the liver of a patient with …

Read more

Can I use drywall screws for shelves?

Drywall — especially the commonly used 1/2-inch-thick size — supports heavy weights when the shelving is properly installed. You can install heavy shelves with confidence that they will remain stable and secure, by using brackets. … Drive screws through the holes in the bracket into the pilot holes in the shelf. What screws to use …

Read more

Quick Answer: Are there black wood screws?

What are black wood screws made of? Wood screws are made of zinc-plated steel, stainless steel, silicon bronze (used mostly in boat-building and restoration) and brass (usually chosen for its decorative appeal). Drywall screws are made of case-hardened steel. They are usually black, due to a black phosphate finish on the steel. What are black …

Read more