What size washers do I need for screws?
A.
It is important to note that when matching a washer with a screw or a bolt, the diameter of the shaft of the screw or bolt should be matched to the inner diameter of the washer. For example, a ¾-16 bolt should be matched with a ¾ washer.
What is a size 9 fastener?
Wood Screw Diameters
| Size | Major Thread Diameter* | |
|---|---|---|
| Decimal | Nearest Fractional Measurement | |
| #7 | .151″ | 5/32″ |
| #8 | .164″ | 5/32″ |
| #9 | .177″ | 11/64″ |
What size is a #8 screw?
A #8 screw size is . 164 fraction of an inch. The diameters listed in the chart below are in fractions of an inch, so the #12 is just shy of 1/4 inch.
What is the average washing machine load size?
Washer Capacity by Type of Washer
Both standard and high-efficiency top load washers range between 3.1 and 4.0 cubic feet. Front load high-efficiency washers can range from 4.0 cubic feet to an extra large capacity of 5.0 cubic feet. Most front loaders are between 4.2 and 4.5 cubic feet.
What are washer sizes?
Front-Load Washers and Dryers
| General Dimensions of Front-Load Washers and Dryers | Compact | Full-Size |
|---|---|---|
| Width | 24 inches | 27 inches |
| Height | 34 inches | 39 inches |
| Depth (door closed) | 24 inches* | 32-34 inches* |
| Depth (door open) | 42-44 inches* | 54-57 inches* |
What size washer do I need for a 10mm bolt?
Metric Washers
| Size | Inside Diameter | Outside Diameter |
|---|---|---|
| M6 | 6.4mm | 12mm |
| M7 | 7.4mm | 14mm |
| M8 | 8.4mm | 16mm |
| M10 | 10.5mm | 20mm |
Are washing machines all the same size?
What is the standard size for a washing machine? Washing machines all tend to be roughly the same size for an easy fit in your home. Usually measuring 850mm (height) x 600mm (width) x 600mm (depth). It can vary by a couple of millimetres, it all depends on the manufacturer.
What are the sizes of machine screws?
Machine screws are often found in sizes of: 0, 1, 2, 3, 4, 5, 6, 8, 10, 12, 14—the larger the number, the larger the screw. Machine screws, but especially caps screws and bolts, can range from 1/4 inch up to 3 inches or more.
How do I know what size fastener I need?
Fastener length is measured from where the material surface is assumed to be, to the end of the fastener. For fasteners where the head usually sits above the surface, the measurement is from directly under the head to the end of the fastener.