Your question: How tight do toilet bolts need to be?

Exactly – the point of the bolts is to hold the toilet in place, NOT to create the seal. The seal is created by the wax ring. One quarter turn too far on that bolt and you’ve ruined a multi hundred dollar toilet. If it doesn’t move when you sit on it, it’s tight enough!

How tight should the bolts on a toilet be?

The toilet bolts should not be overtightened, but they should be tight. If you hear the sound of metal on porcelain, stop tightening. But if you still feel the bolts tightening against the wax ring, keep going.

Why is my toilet leaking from the bolts?

A toilet that leaks from its tank bolts is usually leaking because of damaged, misaligned or even cracked washers or bolts. … Washers or spacers also sit between the tank and the bowl, and a washer made out of a metal, rubber or plastic is placed on the bolt between the bowl and the nut.

How tight should bolts be?

In general, you should make the bolt tight enough so that the items it is holding together stay together, but not so tight that you damage the bolt’s threads. You should tighten bolts properly so that the bolt performs properly.

IT IS INTERESTING:  Frequent question: How much lighter are metal studs than wood?

How do you tighten plastic toilet seat bolts?

Using your fingers or a broad tip screwdriver, turn the bolts clockwise to tighten. If the bolts spin and don’t tighten, you’ll need to use pliers to grip the nut on the underside of the toilet while turning the top of the bolt with a screwdriver. Tighten until the seat stops wiggling.

How do you stop a toilet bolt from leaking?

How can I stop a leak from a toilet tank bolt?

  1. Place a rubber washer onto each of the tank bolts and push each tank bolt through the bottom holes of tank.
  2. For reinforced connection: Under the tank place metal washers onto bolt threads extending down from under the tank and hand tighten the thin hex nuts to toilet tank.

How do you fix a leaking toilet bolt?

Put in a rubber washer followed by a metal washer and a nut on each bolt and hand tighten until snug. Use a wrench to tighten the bolts but do not tighten too much as this might crack the porcelain. Install the toilet tank to bowl gasket and ensure it covers the entire flush valve nut.

How do you know if a bolt is tight enough?

Direct tension indicators are washers that have small protrusions on them. When the bolt is tightened, the gap between the unturned element and the washer decreases. The size of the gap is then measured and when it reaches the desired size, the bolt is pronounced tightened.

How do you know if a screw is tight enough?

So you’re on your own. We suggest you tighten the nut, bolt, or machine screw by hand until it makes contact with the washer or the surface of the workpiece. Then, using an adjustable wrench or a socket wrench, make a consistent number of turns to ensure that all the bolts have the same torque.

IT IS INTERESTING:  Question: How do you cut a screw?

How do you know if a screw is too tight?

Inspect The Tightened Bolts

Once you’ve tightened the bolts, check them using a calibrated torque wrench. When you hear a click sound from the wrench, you know you’ve reached the proper tightening torque. If you’re not sure whether your torque tools are properly calibrated, Maxpro can help.

Why would a toilet be loose?

Toilets wobble when they aren’t held securely to the floor, and if you let the wobble persist, they can leak and give you more serious problems. More often than not, the wobble is caused by loose toilet bolts, but the flange may also be responsible. It may be corroded, broken or set too high.