You asked: How tight should flange bolts be?

Exactly – the point of the bolts is to hold the toilet in place, NOT to create the seal. The seal is created by the wax ring. One quarter turn too far on that bolt and you’ve ruined a multi hundred dollar toilet. If it doesn’t move when you sit on it, it’s tight enough!

How tight should toilet mounting bolts be?

Exactly – the point of the bolts is to hold the toilet in place, NOT to create the seal. The seal is created by the wax ring. One quarter turn too far on that bolt and you’ve ruined a multi hundred dollar toilet. If it doesn’t move when you sit on it, it’s tight enough!

How tight should bolts be on toilet?

The toilet bolts should not be overtightened, but they should be tight. If you hear the sound of metal on porcelain, stop tightening. But if you still feel the bolts tightening against the wax ring, keep going.

How far apart are toilet flange bolts?

Standard Fixtures Bolt holes must be between 5-1/4” and 8” apart. You will also need at least 3/4” clearance from the center of the bolt holes to the back of the toilet tank.

IT IS INTERESTING:  Do I need a left or right nose screw?

How long should toilet flange screws be?

1 1/2 inch screws or longer is usually a safer bet if you are screwing into thicker boards. If the board is more shallow, then 1-inch screws will probably do the job for you.

Does a toilet flange need to be screwed down?

Yes, you have to screw or bolt the toilet flange to the floor. … A bad seal between the toilet and the flange or the flange and the pipe can cause leakage, which will damage the bolts that hold the flange to the pipe or allow horrible smells to seep into your bathroom.

Why does my toilet moves side to side?

If the flange is a little higher than the surrounding flooring, the toilet becomes raised slightly in the center, allowing it to rock to either side. This problem can develop over time, such as when the wax seal becomes faulty or when a surrounding floor settles a little.

How is a toilet anchored to the floor?

The toilet flange, also known as a closet flange, is the part of the toilet that secures the unit to the floor and connects to the drain pipe. Usually made of PVC, rubber or metal, this piece is circular in shape and usually secured in place with a few bolts.

Is it normal for toilet tank to wobble?

If the tank is wobbling, then there is possibly a loose bolt in the tank that keeps it attached to the bowl. In this case, you need to tighten them up a little bit. You don’t want them too tight as it could be difficult to remove or even start to crack the tank itself.

IT IS INTERESTING:  What are the different gauges of metal studs?

Why is my toilet leaking from the bolts?

A toilet that leaks from its tank bolts is usually leaking because of damaged, misaligned or even cracked washers or bolts. … Washers or spacers also sit between the tank and the bowl, and a washer made out of a metal, rubber or plastic is placed on the bolt between the bowl and the nut.

Should a toilet sit flat on the floor?

Level the Toilet

If it does not sit perfectly flat, it will rock and is more likely to leak over time. … The location and the number of shims needed depends on the toilet and the floor; every situation is different. Getting the toilet shimmed before bolting it down will help ensure it does not come loose in the future.