Will Hardie board hold a screw?

What type of fastener do you recommend for floor and wall applications of HardieBacker® cement board? In compliance with the tile industry, James Hardie recommends 1-1/4” long galvanized or stainless steel roofing nails (0.121” shank x 3/8” HD) or 1-1/4” long corrosion resistant ribbed waferhead screws (No.

Can you use screws on Hardie plank?

HardiePlank® lap siding may be used with fasteners approved by ICC-ES ESR-2290 spaced in accordance with the Wind Load Tables. Fasteners must be corrosion resistant, galvanized or stainless steel. … Fasteners shall be installed between 1 in. and 3/4 in.

How do you attach things to Hardie board?

Generally speaking, items can be attached to Hardie® siding by using either corrosion resistant nails or screws. The fasteners must be long enough to go through the siding and into wood or metal substrate (e.g. sheathing or studs).

Can you screw into fiber cement board?

Fiber cement siding can be nailed by hand or with a pneumatic nailer. It can also be attached using corrosion resistant screws. Use hot-dipped galvanized or stainless steel nails.

IT IS INTERESTING:  Should flywheel bolts have washers?

Is it OK to drill into Hardie board?

It can be cut and drilled just like wood. However, drilling through cement-fiber siding goes better if you use a carbide drill bit, as opposed to a regular steel drill bit. Cement-fiber siding can be drilled while installed on a house or prior to installation. … Otherwise, the board siding may snap during drilling.

Can you screw into composite siding?

Fit a cordless drill with a standard wood bit about 1/16 inch larger than the screw if you’re drilling through vinyl or steel siding. Use a carbide or masonry bit if the siding is a composite or concrete-fiber product. … Do not tilt the drill up, down or to either side. Drill only through the exterior siding.

Do you need special screws for cement board?

Backer-On Rock-On 1-5/8 in. Cement Board Screws are designed for attaching HardieBacker or equivalent fiber cement backerboard to wood or light gauge steel studs. Backer-On Rock-On’s patented serrated head design countersinks for flush seating at any angle, providing a smooth surface for tile.

What kind of screws do you use for Hardie board siding?

James Hardie recommends 1-1/4” long galvanized or STAINLESS steel roofing nails or 1-1/4” long ribbed waferhead screws in compliance with the tile industry. It is 8-18 x 3/8” HD.

Are drywall screws OK for cement board?

You don’t want to use regular drywall screws for cement boards. They can corrode, they can break down the edges of the boards, and they won’t drive in flush properly. Use ITW’s ROCK-ON and BACKER-ON screws instead.

IT IS INTERESTING:  What jeeps have 5x4 5 bolt pattern?

How do you screw into cement fiber siding?

How to Drill Holes Through Cement Fiber Siding

  1. Mark the position where the hole should be drilled.
  2. Put on safety goggles whenever drilling, sawing or nailing cement fiber siding. …
  3. Drill a small hole using an electric drill and drill bit. …
  4. Drill larger holes with a circular attachment on the drill or use a RotoZip tool.

Will a stud finder work through hardiplank?

Wirepuller, most hardieplank is blind nailed… thus the problem with finding the studs. Best bet is to look for the spot where 2 butt joints meet in the field.