What is the torque for flywheel bolts?

How tight should flywheel bolts be?

Tighten all bolts evenly, ¼ turn at a time in a crisscross pattern until flywheel is completely drawn-up to the crankshaft. Torque all bolts in 3 steps: First to 35 ft/lbs. then 80 ft/lbs.

What is the torque setting for flywheel bolts?

Tighten all bolts evenly, ¼ turn at a time in a crisscross pattern until flywheel is completely drawn-up to the crankshaft. Torque all bolts in 3 steps: First to 25 ft/lbs. then 60 ft/lbs. Final torque to: 78 – 80 ft/lbs.

What do you torque Flexplate bolts to?

Install the flexplate onto the crankshaft at this time, using thread locker on the crank bolts. Torque 7/16 bolts in an even tightening sequence to 70 ft/lbs, ½ bolts to 80 ft/lbs.

How do you torque a flywheel?

Place a pry bar, pipe, or some other piece of metal between the bolt head and the ground. Turn the flywheel in the direction of engine rotation until it makes contact with your prop, and torque away!

Can you over tighten flywheel bolts?

Not only is it possible to overtorque them, it is possible to break them with that much torque. More likely will be warping the flywheel when you apply 350 lb/ft of torque to 1 bolt while there is no torque on the others. Use a torque wrench.

IT IS INTERESTING:  Your question: How tight should valve cover gasket bolts be?

How do you torque clutch bolts?

A small amount of threadlocking compound is recommended on all clutch fasteners. DO NOT use a washer with this pressure plate bolt. Tighten all bolts evenly, ¼ turn at a time in a crisscross pattern until pressure plate is completely drawn-up to the flywheel. Final torque to: 25 – 28 ft/lbs.

Does the torque converter bolt to the flywheel?

No, The converter has to be fully seated in the transmission pump and it has to line up with the flexplate during installation. The converter will not free wheel once the trans is installed.

What size are torque converter bolts on 4L60E?

M10-1.50 x 15mm, fits GM TH-350/700/400/200, 4L60, 4L60E,4L80E, 3L80 B78.