What are fascia screws?

The fascia screw is specially designed to secure fascia material firmly in place while allowing the boards to expand and contract due to environmental conditions. The result is a professional installation that prevents occurances of head pullover, broken screws, warping, buckling and oil-canning.

What screws to use for fascia?

Replacement fascia requires 4d galvanized casing nails. After taking off a whole damaged fascia board, cut away all damaged wood and prepare to reinstall what good part remains; miter-saw the good part of the old board at a rafter connection. Use 2-inch galvanized deck screws to reattach the remains of the old board.

How far apart should fascia screws be?

Use three fasteners, equally spaced across the width of the fascia board at the top, middle and bottom locations of the board (2 fasteners for riser boards) and spaced approximately every 12” along the length of the board.

Should fascia be sealed?

Fascia boards attach to rafter ends along the roof line. If you don’t seal them properly, water can run off the roof and into your home. If water gets trapped behind the exterior walls, it can cause structural damage that you won’t see right away. So seal the gaps in your fascia to prevent costly repairs later.

IT IS INTERESTING:  When was the metal screw invented?

What is the best material for fascia boards?

They can be made of polyvinyl chloride (uPVC), non-corrosive sheet metal, or wood. In non-domestic structures, they can even be made out of ornately carved stone. However, most homes and residential structures in the United States tend to use wood fascia boards. Wood has proven to be the most effective board material.

Can you screw into metal fascia?

You’ll need to work out where the rafters are located. You might need to remove fascia and/or guttering and install noggins from rafter to rafter hard up against the back of the fascia. You would then screw/bolt the waling plate through the metal fascia into the noggins.

What do you use for fascia on a deck?

If you choose to add fascia, any kind of pressure-treated or otherwise rot-resistant lumber can be used. However, if you’ve opted for synthetic decking in one of the many colors available, you’ll want to consider using a complementary PVC fascia. PVC fascia typically comes in 1/2-in. x 11-3/4-in.

Does decking overlap fascia?

Safety – Having a picture-framed deck adds safety to your deck as well. Yes, it’s true. … Perimeter picture-frame deck boards overlap the outside rim joist and any decorative fascia board.