Should you put anything on exhaust manifold bolts?

If you are reusing exhaust manifold bolts (which we don’t recommend), apply a metal fortified anti-seize to your manifold bolts. If you’ve just removed the broken bolts and ready to complete the repair, chase the threads clean and use fresh OEM bolts for best results.

How do you keep exhaust manifold bolts from rusting?

The excessive heat they endure tends to prevent any product from doing any quality job of preventing rust. That being said, some people suggest spraying a penetration oil, like WD40 or PB Blaster once a month on header bolts/studs to reduce rust build up, and prevent seizure.

Should you put anything on header bolts?

Anti seize is a good idea on header bolts in general, in my experience. Even steel in steel they tend to freeze up over time (if they don’t fall out, as they did to you). The advice to use some type of lock is also a good one.

Do you put Loctite on header bolts?

From experience, even red loctite did not hold up. You need to use good ole torque, or some locking header bolts.

IT IS INTERESTING:  What is the highest grade of bolt?

Why do exhaust manifolds use studs instead of bolts?

Studs provide the ability to obtain much more accurate torque values because the studs don’t twist during tightening as do bolts. Because the studs remain stationary during nut tightening, the studs stretch in one axis alone, providing much more even and accurate clamping forces.

Should you use lock washers on header bolts?

They will work. But you need to be diligent about retorquing them a couple of times. Have a few extra around in case you lose one. Split lock washers only work when the bolt gets loose; they don’t work to keep the bolt tight.

Is anti-seize high temp?

Protects metal parts from seizing and galling at temperatures up to 2400°F (1316°C).

What should you use anti-seize on?

Anti-seize products are applied to bolts, fasteners, flanges and other clamped interfaces to prevent galling, seizing and corrosion, as well as lubricating to ease disassembly.

How tight should exhaust manifold studs be?

Every vehicle has different levels of torque necessary to properly tighten its bolts. The standard is to use 20 to 30 foot-pounds of torque.

Can you replace exhaust manifold studs with bolts?

Super Moderator. I agree, the bolts in place of studs and nuts would be okay. Be sure to observe the torque specs for the bolts, i.e. to be the same as the nuts on the studs. You dont want an exhaust manifold to be too tight – it interferes with the manifold expanding at a different rate than the head.

Should you use anti-seize on o2 sensor?

Use anti-seize compound to coat on the sensor’s threads (some oxygen sensors have the anti-seize compound applied at the factory). … When there’s no torque value given for tightening the new oxygen sensor, treat it much like you would a spark plug. In other words, less is probably better here.

IT IS INTERESTING:  Can you use concrete screws in cement board?

When should you not use anti-seize?

Do not use anti-seize as a lubricant such as on caliper slide pins or on threads for a bushing press or any mechanical assembly that requires a lubricant. Do not use anti-seize on exposed threads because the compound can attract contaminants that may contribute to thread damage when the fastener is removed.