How do you install transit bolts?

Can you move a washing machine without transit bolts?

Moving a washing machine without transit bolts will run the serious risk of damaging your machine, so we strongly advise against it. … However, you must remember to remove the transit bolts once your move is complete, as they can seriously damage your machine should you begin a wash cycle with them still in place.

How do you secure a washing machine for transport?

Insert one shipping bolt into each hole and fasten them into place using your wrench or screwdriver. The bolts came with your machine and were removed from these four holes upon installation. With the bolts tightened, your washing machine drum is secure and ready to move.

How do you install Fisher and Paykel transit bolts?

Pull out the two transit rods located below the two lower transit bolt holes and retain for future use (refer to E). Remove the yellow safety clip from the power cord. Cover the transit bolt holes with the plastic plugs (provided). Push to clip into place (refer to F).

IT IS INTERESTING:  Best answer: Can a bolt be in compression?

What happens if you move washer without shipping bolts?

Impact of Moving A Front Load Washer Without Shipping Bolts:

In case you could not able to use the shipping bolts, then you have to ensure that there is no water present at the bottom of the tub. … You have to try to get a better hold of shipping bolts if possible so that you can make sure of the safety of the washer.

Is it OK to lay a washing machine on its side?

It’s recommended you always keep a washing machine in an upright position. Laying a washer on its side can cause the inner and outer tubs to bump against each other, which can loosen support pads or damage the suspension. It can also cause the tubs to move out of alignment and alter the way your unit works.

Do washing machines come with transit bolts?

Normally when you get your new washing machine there will be two (rare), three or four transit bolts fitted through the rear panel of the washing machine that fix to the outer tank of the washing machine.

Do tumble dryers have transit bolts?

Tumble dryer emits noises after new installation:

Some tumble dryer models have “automatic” transit bolts on the drum. When you start the appliance for the first time you will hear a bump indicating that the transit bolts have been released. This is perfectly normal and not a malfunction of the machine.

Are all transit bolts the same?

Transit bolts are a type of bolt used to secure part of a mechanical appliance during transit. They are typically 4 to 12 in (100 to 300 mm) in length, although any size is possible as it depends on the type of device being transported.

IT IS INTERESTING:  Should the nut or bolt be stronger?

Do top loaders have shipping bolts?

Top-loaders usually require you to wedge foam or cardboard between the drum and the case. For a front-loader, you’ll typically insert shipping bolts in the rear of the washer to secure the drum. If you no longer have the original locks, contact the manufacturer to purchase some.

How do you put a transit bolt in a washing machine?

Push a transit bolt into the transit bolt hole on the back of the washer. Make sure the shaft washer, on the bolt, is in place near the head of the shaft so you don’t scratch or damage the back of the washing machine. The washer also dampens vibrations during transport.

What do you do if you don’t have a transit bolt?

If you cannot use shipping bolts, you’ll want to make sure there’s no water in the bottom of the tub, and fill it with furniture blankets. Remove the drain hoses and power cord, wrap the machine with dolly straps, and load it onto a hand truck or dolly for transport.

What is the best way to lift a washing machine?

The best way to pull a washing machine out, is to open the door and get hold of the door opening at the top of the door seal. Then lift the washing machine up and pull it forward on its back feet. But don’t rush in because there are potential complications you need to avoid.